2012 National Registry Hip Resurfacing Information
Primary Total Resurfacing Hip Replacement
Read Full Report by clicking here
2012 ANNUAL REPORT
There have been 14,901 total resurfacing procedures reported to the Registry,
an additional 603 procedures, compared to the last report.
The use of resurfacing hip replacement in Australia continues to decline. The
number of procedures reported in 2011 was 39.7% less than in 2010 and 68.5% less
compared to the peak in 2005.
Osteoarthritis is the principal diagnosis for total resurfacing hip
replacement (95.0%), followed by developmental dysplasia (2.5%) and
Most patients are male and the proportion of males has increased from 71.2%
in 2003 to 94.3% in 2011
There continues to be a shift in the use of primary total resurfacing hip
replacement to younger patients. The proportion of patients under the age of 55
years has continued to increase and accounted for 62.6% of all primary total
resurfacing procedures in 2011. There has been a corresponding decrease in use
for patients aged 55-64 years (Figure HT34).
The majority of total resurfacings use hybrid fixation (98.3% in 2011).
The BHR remains the most used resurfacing hip prosthesis in 2011. Although
its use has declined in absolute numbers in 2011 the proportion of resurfacing
procedures using BHR has increased from 62.6% in 2010 to 75.4% in 2011 (Table
The BHR resurfacing prosthesis has a cumulative percent revision at 11 years
Note about Total Hp Replacement Information:
At 11 years, hybrid fixation has the lowest cumulative percent revision of
6.0% compared to cemented (7.2%) and cementless fixation (7.8%) (Information
from 2012 National Registry under Total Hip Replacement Information)
The cumulative percent revision at 11 years for primary total resurfacing hip
replacement undertaken for osteoarthritis is 9.5% (Table HT62 and Figure HT35).
Reasons for Revision
The main reasons for revision of primary total resurfacing hip replacement
are loosening/lysis (33.6%), fracture (25.7%), metal sensitivity (16.6%),
infection (7.2%) and pain (6.0%) (Table HT63).
The five most common reasons for revision are shown in Figure HT36. The
incidence of revision for fracture increases rapidly in the first year, however
after this time the incidence increases at a slower rate. Loosening/lysis shows
a linear increase and at just over four years exceeds fracture to become the
most common reason for revision. The incidence of revision for metal sensitivity
continues to increase.
Type of Revision
The main types of revision of resurfacing hip replacement are total hip
replacement (53.3%), isolated femoral (38.5%), and acetabular only (5.2%) (Table
HT64). In previous reports the most common type of revision was femoral only
revision. This year the Registry is reporting a change. Revision of both the
acetabular and femoral components to a total conventional hip replacement is now
the most common type of revision for resurfacing hip replacement.
The outcomes of the three most common primary diagnoses (osteoarthritis,
developmental dysplasia and osteonecrosis) are listed in Tables HT65 and HT66.
Primary total resurfacing hip replacement for osteoarthritis has a significantly
lower rate of revision compared to developmental dysplasia (Figure HT37).
Age and Gender
There is a higher rate of revision for patients 65 years or older for the
first six months, after this time there is no difference compared to the other
age groups (Tables HT67 and HT68 and Figure HT38).
Females have an increased rate of revision compared to males. After six
years, females have over four times the rate of revision compared to males
(Tables HT69 and HT70 and Figure HT39). While there is no age related difference
in the rate of revision for females (Tables HT71 and HT72 and Figure HT40),
there is an age related revision rate associated with males. Males over the age
of 65 years have an increased rate of revision compared to males less than 55
years for the first six months and for males between the ages of 55 to 64 years
for the first three months only (Tables HT71 and HT72 and Figure HT41).
There is a relationship between femoral component head size and the rate of
revision. Femoral head sizes of 44mm or less have more than three times the rate
of revision compared to head sizes 50-54mm. Head sizes 45-49mm have over twice
the rate of revision compared to head sizes 50-54mm (Tables HT73 and HT74 and
Figure HT42). The effect of femoral component head size is evident in both males
and females. Females have an increased rate of revision independent of head size
though this is only apparent in head sizes greater than or equal to 50mm after
seven years (Tables HT75, HT76 and Figure HT43).
Revision diagnosis cumulative incidence varies with head size. Head sizes
less than 50mm have a higher incidence of the five most common reasons for
revision (Figure HT44).
Revisions per 100 observed component years and yearly cumulative percent
revision of total resurfacing hip prostheses are listed in Tables HT77 and HT78.
There are seven prostheses with over 1,000 observed component years, the ASR,
Adept, BHR, Cormet, Cormet 2000 Bi-coated, Durom and Mitch TRH. The BHR
resurfacing prosthesis has a cumulative percent revision at 11 years of 7.1%.
Information Below about Total Hip Replacement Information to compare to Hip
Note by Patricia Walter
I added the information below so people can
compare the outcomes
of hip resurfacing to total hip replacement.